DTC Eraser / Error Code Cleaner
Professional Standalone Recovery for Liebherr XPower Wheel Loaders (ECU2)
 
The Liebherr XPower Error Code Cleaner is a specialised, standalone diagnostic tool engineered for the latest generation of wheel loaders equipped with Tier 4 Final engines. Designed for rapid, on-site recovery, this tool communicates directly with the ECU2 Engine Control Unit, allowing you to clear critical faults without a laptop, complex software, or dealer-level configuration.
When an XPower loader enters an "Inducement" state (SCR-related power reduction), it can halt an entire load-out operation. This "Plug & Go" interface allows operators and fitters to reset the system and restore full engine torque in under 10 seconds.
 
Key Capabilities
Clear Active & Inactive Codes: Instantly wipes stored engine fault codes from the ECU.
Reset SCR Inducement: Automatically clears power reductions and "Limp Mode" restrictions caused by emissions faults.
History Clearance: Clears the ECU2 error code history for a clean diagnostic status.
Standalone Operation: No subscription or external hardware required—ideal for remote quarry and construction sites.
 
Operation Guide (Simple 4-Step Process)
Switch the machine ignition to the ON position.
Connect the tool to the Deutsch 9-pin diagnostic connector (SAE J1939).
Wait approximately 10 seconds while the device processes the command.
Done – Engine error codes and inducements have been cleared.
 
Supported Machine Series:
Liebherr XPower Wheel Loaders: (Tier 4 Final / Stage IV).
Control Unit: Specifically designed for the ECU2 Engine Control Unit.
Interface: Deutsch 9-pin Diagnostic Connector.
 
Compatible XPower Models:
L550 / L556
L566 / L576
L580 / L586